Order the wrong door size and everything else — the opener, the tracks, the fitting date — unravels. Width gets most of the attention, but garage door height is the dimension that decides whether your vehicle actually fits, especially if you drive a tall SUV, a van or anything with a roof box. This guide sets out the standard heights used in homes today, explains what each height realistically fits, and shows you how to measure your own opening properly before you order.
Standard Garage Door Heights
Most residential garage doors come in two standard heights: 7 feet (2.13 m) and 8 feet (2.44 m). The 7 ft door is the long-standing default on older homes and still suits the majority of family cars, which typically stand between 1.4 m and 1.7 m tall. The 8 ft door has become the safer modern choice because vehicle heights have crept up: many popular SUVs sit between 1.7 m and 1.85 m before you add roof rails, antennas or a cargo box.
Beyond the two standards, manufacturers offer 7 ft 6 in and 9 ft heights in sectional ranges, and custom heights up to 10–12 ft for RV garages, workshops and homes with lifts. Custom sizes cost more and take longer to manufacture, so it is worth confirming whether a standard size plus a high-lift track conversion solves the problem first — our overhead garage door guide explains how high-lift hardware lets a taller door work in a standard opening. Height is only half the opening, so read this alongside our guide to standard garage door width to size the full frame.
What Actually Fits Through Each Height
Remember that the usable clearance is slightly less than the nominal door height, because the bottom seal and the lowest panel edge sit in the opening when the door is closed, and the doorway floor may slope. As a working rule, allow at least 10–15 cm between the top of your vehicle (including anything mounted on the roof) and the underside of the open door or its lowest obstruction.
A 7 ft (2.13 m) opening comfortably fits hatchbacks, saloons and compact crossovers, and most mid-size SUVs driven carefully on level ground. An 8 ft (2.44 m) opening is the sensible minimum for full-size SUVs, pickup trucks, people carriers and any vehicle carrying bikes or a roof box. Vans, motorhomes and boats on trailers need 9 ft or more, and at that point most owners move to a purpose-sized door rather than adapting a standard one. If you are still choosing the door format itself, our breakdown of the types of garage doors compares how sectional, roller and up-and-over doors use the opening differently.
Headroom: The Measurement People Forget
Door height is measured on the opening; headroom is the space above the opening inside the garage, and the door system needs it. A standard sectional door with torsion springs typically needs around 30 cm of headroom above the opening for the tracks to curve back horizontally, plus more if a high-lift or low-headroom kit is not used. The opener’s rail and motor also hang below the ceiling line, so measure to the lowest obstruction — a beam, a light fitting or the opener itself — not to the ceiling.
We cover the full method in our dedicated guide to garage door headroom, and it is worth reading before you fall in love with a taller door: raising the opening height without checking headroom is the most common sizing mistake we see, and it usually surfaces on installation day, when the options are expensive.
How to Measure Your Garage Opening
Measure the finished opening, not the old door. Take the height from the floor to the underside of the lintel at the left, centre and right, and use the smallest figure — floors and lintels are rarely perfectly level. Measure the width the same way, between the reveals, and note any taper. Then measure the headroom from the top of the opening to the lowest ceiling obstruction, and the side room on each side of the opening for the vertical tracks (typically 10–15 cm each side).
Finally, measure your vehicle honestly: the highest fixed point, usually the roof rails or shark-fin antenna, plus anything you regularly carry on top. Write all five numbers down and give them to your supplier. The budgeting side of the job — what fitting, hardware and disposal add to the door price — is covered in our walkthrough of the garage door installation process and cost factors.
When to Go Taller Than Standard
Choose 8 ft over 7 ft if you are building new or replacing the lintel anyway; the price difference is modest and it future-proofs the garage for taller vehicles. Go taller still if you plan a vehicle lift, store a van or motorhome, or run a home workshop with tall equipment. Whichever height you choose, finish the opening properly: a new garage door weather seal sized to the door keeps dust and driving rain out of the gap that every door needs to operate.
One more check before you order: open and close your current door and watch the top panel as it travels. If it already passes close to the opener rail or a ceiling beam, a taller replacement door on standard tracks will follow the same path, so the clearance you see today is the clearance you will keep. If it is already tight, ask your installer about low-headroom hardware at the quoting stage rather than after the door arrives.
Garage door height looks like a small detail until the day a tall vehicle meets a short opening. Measure the opening, measure the vehicle, respect the headroom, and the door you order will be the door that fits — first time, every time.